Yamaha MX775 Service Manual page 104

THROTTLE BODY ASSEMBLY
1
2
1
3
4
5
6
7
c
8
9
10
3
1
2.
a
TIP
• Install the bending portion (short) "a" of the governor
b
spring "1" into the hole "c" of the throttle lever comp while
installing the bending portion (long) "b" of the governor
spring "1" into the hole "d" of the governor assembly.
• Install the governor spring to the throttle lever comp first,
and then to the governor assembly.
d
3.
2
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4.
Install:
• Link rod/spring
• Throttle lever comp
• Governor assembly
• Governor spring "1"
Adjust:
• Governor
• Governor assembly
a. Loosen the governor assembly bolt "1".
b. Turn the governor assembly "2" counterclockwise
until it stops.
c. Turn the governor fork "3" counterclockwise until it
stops.
d. Tighten the governor assembly bolt "1".
Governor assembly bolt:
8 N·m (0.8 kgf·m, 5.8 lb·ft)
Check:
• Engine speed
(Refer to "ENGINE SPEED" on page 2-14)
High engine speed (with no load):
3550–3600 r/min
Low engine speed (with no load):
1450–1550 r/min
4-8