Led Lamp; Installing The Dk Roll - Brother QL-500 User Manual

LED Lamp

The LED lamp on the QL-500/560 indicates the current operating condition.
Lamp
Not lit
Lit
Flashing fast
Flashing slow
Turns off after flashing
fast ten times

2 Installing the DK Roll

1
Press the ON/OFF button to turn the QL-500/
560 off. Hold the DK Roll compartment cover at
the sides near the front of the QL-500/560 and
firmly lift up to open the cover.
2
Place the spool into the spool guides in the DK
Roll compartment.
Make sure that the spool arms are inserted firmly in
•
the spool guides on the left and right.
Insert the spool with the DK Roll located on the right
•
hand side of the QL-500/560.
Power is OFF.
Power is ON.
(Normally lit while power is on, the LED flashes during cleaning or if an
error has occurred.)
Indicates one of the following errors.
• Cutter error
• Label sensor error
(DK Roll not installed correctly, end of DK Roll, or label jam)
• DK Roll compartment cover is open during operation
• Incorrect DK Roll installed
• No DK Roll installed
Cooling
(Waiting for temperature of print head to lower)
System error
Turn the QL-500/560 off and then on again.
If this error re-occurs, contact the retail outlet where the QL-500/560 was
purchased or your local authorized service centre.
Condition
9
STEP
1
STEP
2