Unpacking; Assembly; Base & Column - Hafco bd-325 Instruction Manual

Page 9

UNPACKING

The drill press is delivered with the components shown last page.Check the parts
against the above list. Should there be any deficiencies or damage,you should
contact your dealer immediately where the product was originally purchased.Do
not discard the packaging un l the machine is assembled. The packaging consists
of cardboard and appropriately marked materials which can be sent to a
re-cycling facility.
To protect the machine parts from moisture, a protec ve coa ng of light machine
oil will have been applied to the outside surfaces. Remove any excess with a paper
towel.
Take care when li ing the head assembly, considering its weight.
Before use, the machine must be mounted, and securely bolted, to a strong,heavy
workbench, of sufficient height that you will be standing upright when working.
Ensure the work place is adequately lit, and that you will not be working in your
own shadow.

ASSEMBLY

WARNING!During assembly ensure the drill press is disconnected
from the power supply.
Carefully remove contents from the packing box.
Select a firm, level surface on which to assemble the drill press.
BASE & COLUMN
1. Select the base (Fig. 1)and align the column support over the large hole
(Fig. 2).
2. Align the holes in the column support with those in the base and secure in
place using the bolts and washers.Using a spanner securely ghten all bots
(Fig. 3).
3. We recommend moun ng the base to stable surface for proper support.
4. Slide the column into the column support(Fig.4).
Instructions Manual for BD-325 (D590)
8
19/11/2015