Philips 200AW8 User Manual page 12

Imaging Problems
Display position is incorrect
Image vibrates on the screen
Vertical flicker appears
Horizontal flicker appears
The screen is too bright or too dark
An after-image appears
An after-image remains after the
power has been turned off.
Press the Auto button.
Adjust the image position using the
Horizontal Position and/or Vertical
Position in OSD Main Controls.
Check that the signal cable is
properly connected to the graphics
board or PC.
Press the Auto button.
Eliminate the vertical bars using the
Phase/Clock of More Settings in OSD
Main Controls.
Press the Auto button.
Eliminate the vertical bars using the
Phase/Clock of More Settings in OSD
Main Controls.
Adjust the contrast and brightness on
OSD Main Controls. (The backlight of
the LCD monitor has a fixed life span.
When the screen becomes dark or
begins to flicker, please contact your
dealer).
If an image remains on the screen for
an extended period of time, it may be
imprinted in the screen and leave an
after-image. This usually disappears
after a few hours
This is characteristic of liquid crystal
and is not caused by a malfunction or
deterioration of the liquid crystal. The
after-image will disappear after a
peroid of time.