Network; Remote Code; Hide Mode - JVC DLA-RS4500 Instructions Manual

Network

For specifying the settings for external control from a PC or smartphone.
Setting
DHCP Client On
Off
IP Address
Subnet Mask
Default Gateway
MAC Address
Set
Control4 SDDP
Glossary of Network Terminology
DHCP
IP Address
Subnet Mask
Default Gateway
MAC Address

Remote Code

For changing the remote control code.
Setting
A
B
You need to configure the remote control according to the settings of this unit.
0
On the remote control unit, press the [MENU] and [BACK] buttons at the same time for three seconds or longer to
switch the code.
The backlight of the remote control blinks 3 times: change the remote control code to "A"
0
The backlight of the remote control blinks 2 times: change the remote control code to "B"
0

Hide Mode

For reducing the power consumption through suppressing the output current of the LD block when the [HIDE] button
is pressed to hide the image temporarily.
Setting
Off
On
Obtains the IP address automatically from the DHCP server inside the connected
network.
For configuring the network settings manually.
For configuring the IP address.
For configuring the subnet mask.
For configuring the default gateway.
Displays the MAC address of the unit.
Applies the network settings.
Set to "On" to allow Control4 SDDP to detect this unit.
When this unit is not connected to an environment under the control of the controller
and Control4 SDDP from the Control4 Corporation, set this to "Off".
: Abbreviation for Dynamic Host Configuration Protocol. This is a protocol for the network
to assign an IP address automatically to the connected device.
: Numeric characters for identifying the device that is connected to the network.
: Numeric characters that define the bit count used for the network address that is a
segment of the IP address.
: Server for communicating beyond the network that is divided by the subnet mask.
: Abbreviation for Media Access Control address. This is a number that is unique to each
network adapter. Each of the network adapters is assigned with a unique MAC address.
Change the remote control code from "B" to "A".
Change the remote control code from "A" to "B".
Do not suppress the output current when the [HIDE] button is pressed to hide the
image temporarily.
Suppresses the output current when the [HIDE] button is pressed to hide the image
temporarily.
Description
Description
Description
59