Kohler command pro CH742 Service Manual page 67

Governor Lever Hole Position
F
B
C
D
E
A Governor Lever
C Hole 2
E Hole 4
Governor Lever and Hole Position/RPM Chart
(Governed Idle, 10% Regulation)
Governed Idle Spring Assembled in Hole G
Gov. Lever
High Idle RPM
Hole No.
3900
3850
3800
3750
3700
3650
3600
3550
3500
3450
3400
3350
3300
3250
24 690 34 Rev. D
A
B Hole 1
D Hole 3
F Hole G
Governor Spring
Color Code
3 Black
3 Black
2 Orange
2 Orange
3 Clear
2 Blue
2 Red
2 Clear
2 Clear
2 Clear
1 Black
1 Red
1 Red
3 Yellow
KohlerEngines.com
Install Oil Sentry (if equipped)
™
1. Apply pipe sealant with Tefl on
or equivalent) to threads of Oil Sentry
install it into breather cover. Torque to 4.5 N·m
(40 in. lb.).
2. Connect wire lead (green) to Oil Sentry
Install Control Panel (if equipped)
1. Install panel to blower housing.
2. Connect throttle control cable or shaft.
3. Connect choke control cable to control bracket.
4. Connect Oil Sentry
™
Install Valve Covers
Torque Sequence
1
4
1. Make sure sealing surfaces are clean.
2. Make sure there are no nicks or burrs on sealing
surfaces.
3. Install a new O-ring in groove of each cover.
4. Locate cover with oil fi ll neck on same side as
removed and install lifting strap in original position.
Position cover on cylinder head. Install four screws
in each cover and fi nger tighten.
5. Torque valve cover fasteners to 6.2 N·m (55 in. lb.)
using sequence shown.
Reassembly
(Loctite PST
® ® ®
switch and
™
terminal.
™
indicator light wires.
3
2
592™
67