Installation Procedure - Lochinvar FTXL Installation & Operation Instructions

2
CON·X·US Installation

Installation procedure

1. Using four (4) 100053762 screws, install the four (4)
standoff s (100134798) into the four (4) small holes on the
front right side of the unit (see FIG.'s 2-2A through
2-2F).
2. Using four (4) 100053762 screws, install the CON·X·US
board (100094892) onto the standoff s installed in Step 2.
Figure 2-2A_Install FTXL CON·X·US Board
NOTE: FTXL Models Only:
a. Install two (2) push rivets (100134843) on the right side of the unit (reference Detail A). Once installed attach the harness
clips (100137491) to the push rivets on the inside of the unit (Detail A), above the main control panel.
b. Install two (2) bushings (100163015) into the left and right side of the CON·X·US board.
4
Table 2B - List of bracket kits
Part #
100265396
100265397
CON·X·US BOARD
A
4X STAND-OFF, #6x1/2" HEX
Installation and Operation Instructions
Description
KIT,BRKT,BEZEL,CONXUS,KB
KIT,BRKT,BEZEL,CONXUS,WH
4X SCREW, PHP, 6-32 X 1/4 STL
4X SCREW,PHP,6-32 X1/4,STL
2X RIVET, NYLON PUSH
2X HARNESS CLIPS
DETAIL A
2X BUSHING, SNAP, 1-1/4"
IMG01102