Vaillant AROTHERM VWL ../2 A series Operating Instructions Manual

Vaillant AROTHERM VWL ../2 A series Operating Instructions Manual

Advertisement

Quick Links

For the operator
Operating instructions
Publisher/manufacturer
Vaillant GmbH
Berghauser Str. 40
D-42859 Remscheid
Tel. +49 21 91 18‑0
Fax +49 21 91 18‑28 10
info@vaillant.de
www.vaillant.de
aroTHERM
VWL ../2 A 230 V
Operating instructions
GB

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AROTHERM VWL ../2 A series and is the answer not in the manual?

Questions and answers

Summary of Contents for Vaillant AROTHERM VWL ../2 A series

  • Page 1 Operating instructions For the operator Operating instructions aroTHERM VWL ../2 A 230 V Publisher/manufacturer Vaillant GmbH Berghauser Str. 40 D-42859 Remscheid Tel. +49 21 91 18‑0 Fax +49 21 91 18‑28 10 info@vaillant.de www.vaillant.de...
  • Page 2: Table Of Contents

    Contents Contents Setting the target feed temperature in heating mode..15 Safety ..........3 Setting a room thermostat or weather compensator ....15 Action-related warnings ....3 Checks and maintenance General safety information..... 3 carried out by the operator... 15 Intended use ........
  • Page 3: Safety

    Safety 1 1 Safety larly the "Safety" section and the warnings. 1.1 Action-related warnings 1.2.2 Risk of death due Classification of action-re- to explosions and lated warnings scaldings from brine The action-related warnings fluid are classified in accordance with the severity of the pos- The brine fluid ethylene and sible danger using the following propylene glycol is extremely...
  • Page 4 1 Safety particularly at risk, even at lower 1.2.4 Preventing the risk of injury from corrosive temperatures. brine fluid ▶ Select the temperature so that nobody is at risk. The brine fluid ethylene glycol is harmful to health. 1.2.7 Risk of death due to lack ▶...
  • Page 5 Safety 1 ▶ Avoid skin or eye contact with the operational safety of the the coolant. product can no longer be en- ▶ In the event of skin or eye sured and the guarantee there- fore becomes void. contact with the coolant, seek medical advice.
  • Page 6 1 Safety Frost protection and monitoring during a power cut, note the fol- devices are only active while lowing: the product is connected to ▶ Contact your competent per- the power supply. The product son for advice on installing an must be connected to the power emergency power generator.
  • Page 7: Intended Use

    1.3.1 State-of-the-art escaping coolant technology The product contains R410A The Vaillant aroTHERM heat coolant. The coolant must not pump systems are construc- be allowed to escape into the ted using state-of-the-art tech- atmosphere. R410A is a fluor-...
  • Page 8: Ce Label

    1.3.5 Observing other applicable documents Intended use also includes the observance of accompanying operating, installation and ser- vicing instructions for Vaillant products as well as for other parts and components of the system. 1.3.6 Liability and secondary clauses...
  • Page 9: Notes On The Documentation

    Notes on the documentation 2 2 Notes on the documentation 2.1 Observing other applicable documents ▶ You must observe all operating instruc- tions enclosed with the system compon- ents. 2.2 Storing documents ▶ Keep this manual and all other applic- able documents safe for future use.
  • Page 10: Product Description

    3 Product description 3 Product description 3.1 Design of the heat pump system The heat pump system consists of the following components: – Heat pump – VWZ AI heat pump control module – Additional hydraulic components, if required – System controller The heat pump can be operated by the VWZ AI heat pump control module.
  • Page 11: Type Designation And Serial Number

    Product description 3 3.2 Type designation and serial 3.4 Digital Information and number Analysis System (DIA) The product is equipped with a Digital In- formation and Analysis System (DIA sys- tem). This system provides information on the operating status of the product and helps you to rectify faults.
  • Page 12: Operation

    4 Operation – You can go one selection level lower in Access to the Display of the menu for addi- symbols for the the menu. tional information active operat- By pressing at the same time: Display of the ing status of the –...
  • Page 13: Operating Levels

    Operation 4 As soon as a fault message is present, Setting level Unit the basic displays switches to the fault Heating message. Cooling 4.3 Operating levels Menu → Live Monitor The product has two operating levels. Heating: The operating level for the operator shows Compressor switch-off the most important information and offers Building circuit...
  • Page 14: Displaying The Building Circuit Pressure

    5 Operation 4.6 Displaying the building circuit 4.11 Setting the language pressure If you want to set another language: ▶ Menu → Live Monitor → Building circuit Press and hold at the same pressure time. ▶ – You can display the current filling pres- Also press the fault clearance key for a short time.
  • Page 15: Operating Noises

    Operation 5 5.2 Operating noises 5.3 Activating frost protection ▶ To prevent the product from freezing, ensure that the product is switched on. "Hhmmm..." (*) 5.4 Setting the target feed temperature in heating mode The actual target flow temperature is auto- matically determined by the system con- "Ttsheeh...!"...
  • Page 16: Having The Product Temporarily Decommissioned

    6 Troubleshooting 3. Do not clean the product with a high- 2. The maintenance intervals depend on pressure cleaner. the local conditions and the use of the product. 4. At regular intervals, check that no branches or leaves have gathered 3.
  • Page 17: Detecting And Rectifying Faults

    Troubleshooting 6 6.2 Detecting and rectifying faults This section shows all of the fault messages that can be rectified without seeking help from the competent person in order to start up the product again. Remedy (→ Page 17) ▶ If the product still does not function after the fault has been rectified, contact your competent person.
  • Page 18: Decommissioning

    9.1 Guarantee ▶ Have a competent person permanently Vaillant provides a full parts and labour decommission the product. guarantee for this appliance for the dura- tion as shown on the enclosed registration card which must be fully completed and 8 Recycling and disposal returned within 30 days of installation.
  • Page 19: Customer Service

    Guarantee and customer service 9 all costs associated with this service are excluded from this guarantee. Failure to install and commission this ap- pliance in compliance with the manufac- turer’s instructions will invalidate the guar- antee (this does not affect the customer’s statutory rights).
  • Page 20 0020151761_04 20.11.2015 Vaillant Ltd. Nottingham Road Belper Derbyshire DE56 1JT Telephone 0330 100 3461 info@vaillant.co.uk www.vaillant.co.uk © These instructions, or parts thereof, are protected by copyright and may be reproduced or distributed only with the manufacturer's written consent.

Table of Contents