Electrical Connection; Adjusting The Feet; Connecting To The Drain - Beko WTV 7531 X0 User Manual

2. Open the taps completely after making the hose connection to
check for water leaks at the connection points. If any leaks occur,
turn off the tap and remove the nut. Retighten the nut carefully
after checking the seal. To prevent water leakages and damages
caused by them, keep the taps closed when the machine is not in
use.

2.5 Connecting to the drain

• The end of the drain hose must be directly connected to the
wastewater drain or to the washbasin.
A
CAUTION:
Your house will be flooded if the hose comes
out of its housing during water discharge. Moreover, there is
risk of scalding due to high washing temperatures! To prevent
such situations and to ensure smooth water intake and
discharge of the machine, fix the end of the discharge hose
tightly so that it cannot come out.
• The hose should be attached to a height of at least 40 cm, and
100 cm at most.
• In case the hose is elevated after laying it on the floor level or
close to the ground (less than 40 cm above the ground), water
discharge becomes more difficult and the laundry may come out
excessively wet. Therefore, follow the heights described in the
figure.
• To prevent flowing of dirty water back into the machine and to
allow for easy discharge, do not immerse the hose end into the
dirty water or do not drive it in the drain more than 15 cm. If it is
too long, cut it short.
• The end of the hose should not be bent, it should not be stepped
on and the hose must not be pinched between the drain and the
machine.
• If the length of the hose is too short, use it by adding an original
extension hose. Length of the hose may not be longer than 3.2 m.
To avoid water leak failures, the connection between the extension
hose and the drain hose of the product must be fitted well with an
appropriate clamp as not to come off and leak.
6 / EN

2.6 Adjusting the feet

A
CAUTION:
In order to ensure that the product operates
more silently and vibration-free, it must stand level and
balanced on its feet. Balance the machine by adjusting the
feet. Otherwise, the product may move from its place and
cause crushing and vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level and balanced.
3. Tighten all lock nuts again by hand.
A
WARNING:
Do not use any tools to loosen the lock nuts.
Otherwise, they will get damaged.

2.7 Electrical connection

Connect the product to a grounded outlet protected by a 16 A fuse.
Our company shall not be liable for any damages that will arise when
the product is used without grounding in accordance with the local
regulations.
• Connection must comply with national regulations.
• Power cable plug must be within easy reach after installation.
• If the current value of the fuse or breaker in the house is less than
16 Amps, have a qualified electrician install a 16 Amp fuse.
• The voltage specified in the "Technical specifications" section
must be equal to your mains voltage.
• Do not make connections via extension cables or multi-plugs.
B
DANGER:
Damaged power cables must be replaced by the
Authorized Service Agents.
Transportation of the product
1. Unplug the product before transporting it.
2. Remove water drain and water supply connections.
3. Drain all water that has remained in the product.
4. Install transportation safety bolts in the reverse order of removal
procedure;
C
NOTE :
Never move the product without the transportation
safety bolts properly fixed in place!
A
CAUTION:
Packaging materials are dangerous to children.
Keep packaging materials in a safe place away from reach
of the children.
Washing Machine / User's Manual