Belt Replacement - BRADLEY MOWERS 48SC Owner's Manual & Parts List

Note: Use belts designed for commercial mowers.
CUTTERDECK BELT
1. Remove center, left and right belt guards.
2. Set the cutterdeck in a middle height-of-cut
position.
3. Loosen bolt on belt guide so belt guide can be
moved to remove the belt.
4. Loosen nut W and nut Q to back tensioning idler
off to remove belt from idler. Remove belt from
cutterdeck pulleys.
5. Remove belt from clutch pulley.
6. Install the new belt by performing these steps
in reverse order.
7. Cutterdeck spring will require tension
adjustment after belt installation. Adjust nut W
and nut Q to gain the appropriate tension.
TRANSAXLE DRIVE BELT
1. Remove engine-cutterdeck belt.
(See cutterdeck belt above)
2. Loosen nut Y on clutch damper so clutch
damper can be moved to remove the belt.
3. Loosen nut Z to remove the transaxle drive belt.
4. Install a new transaxle drive belt by
performing these steps in reverse order.
NOTE: Inspect the fans. Replace if worn or
damaged.
5. Reinstall cutterdeck belt and guards.
20
Bradley Stand-On Compact Mower Owner's Manual