Safety Information; Description Of Warnings; General Information - BMG Labtech spectrostar nano Operating Manual

Table of Contents

Advertisement

BMG LABTECH
2

Safety Information

2.1

Description of warnings

The warning signs used throughout this manual adhere to the description set forth in DIN 4844-2.
A general warning calls attention to a condition which is further described and must be
strictly followed by the operator
Warning for optical radiation
2.2

General Information

This instrument must be installed and used as lined out in this Operating Manual.
Installation, service and any operation which requires opening the instrument must be
performed only by trained and certified personnel from BMG LABTECH. Failure to
comply with these instructions will impair or even invalidate the warranty and can lead
to unsafe operation of this equipment
The area designated for the instrument should be free of dust, liquids and acidic
vapour. The surface of the table should be flat and even. Avoid areas subject to
vibrations and direct sunlight
Prior to turning the instrument on the first time let the instrument adapt to room
temperature for at least 3 h to avoid condensation causing a short circuit.
BMG LABTECH will void the warranty if damage occurs to electrical and/or mechanical
parts in case the instrument was turned on before the recommended accommodation
time
Handling and operation of the equipment must be carried out only by qualified
personnel and staff trained by an official BMG LABTECH representative
Samples and reagents, be it in solid, liquid, or gaseous form, must be removed from
the instrument immediately after measurement to avoid corrosion and accumulation of
hazardous substances inside the instrument
2012-07-18
SPECTROstar Nano Operating Manual
0601B0001C
7/16

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the spectrostar nano and is the answer not in the manual?

Table of Contents

Save PDF