Upgrading By Ftp; Restoring Default Settings - HIKVISION DS-7104HGHI-F1/N User Manual

Step 5 Click the Upgrade button to start upgrading.
Step 6 After the upgrading is complete, reboot the DVR to activate the new firmware.

16.5.2 Upgrading by FTP

Before you start
Configure PC (running FTP server) and DVR to the same Local Area Network. Run the 3
TFTP software on the PC and copy the firmware into the root directory of TFTP.
Step 1 Enter the Upgrade interface.
Menu > Maintenance > Upgrade
Step 2 Click the FTP tab to enter the Local Upgrade interface, as shown in Figure 16-8.
Step 3 Enter the FTP Server Address in the text field.
Step 4 Click the Upgrade button to start upgrading.
Step 5 After the upgrading is complete, reboot the DVR to activate the new firmware.

16.6 Restoring Default Settings

Step 1 Enter the Default interface.
Menu > Maintenance > Default
Step 2 Select the restoring type from the following three options.
Restore Defaults: Restore all parameters, except the network (including IP address, subnet
mask, gateway, MTU, NIC working mode, default route, server port, etc.) and user account
parameters, to the factory default settings.
Digital Video Recorder User Manual
Figure 16-8 FTP Upgrade Interface
Figure 16-9 Restore Defaults
251
rd
-party