Fill The Water Tank - Health O Meter NUYU Owner's Manual

Set-up Instructions

FILL THE WATER TANK

Find a space for your Sleep System next to your bed and
1
set it on the floor. Do not place under your bed.
Twist to the unlocked position and lift the green cap to
2
open the water tank.
Using distilled water only, fill the water tank until the
3
MAX FILL line has been reached. Keep some extra water
nearby, as you may need to fill the tank a second time
after powering on the Sleep System. You will need about 1
standard sized water bottle worth, or 500mL.
4
Replace the green cap and twist to the locked position.
SET UP YOUR SLEEP SYSTEM
Attach the sleep mat to the water tank. To do this, firmly
1
push the connector of the grey hose onto the grey
receiver of the water tank. You should feel it click, which
confirms it is connected. If you do not feel it click, please
press until it clicks.
After you've found a good space for your Sleep System,
2
filled it with water, and have attached the sleep mat, plug
it into a wall outlet.
Place the sleep mat under your fitted sheet, and over
3
your mattress cover or mattress (if you do not use a
mattress cover).
Place the sleep mat under where the torso section of
4
your body typically lays on your bed. It is recommended
that you place the top of the sleep mat just below where
your pillow ends. This way, the sleep mat will be lying
underneath your torso, from your shoulders to below your
hips. Please adjust the sleep mat so that the connector
tube is hanging off the bed.
Ensure that the grey connector hose does not get
pinched where it is set up. This will prevent water flow
and may cause excess noise from the water tank.
5