Using The Right Hand Table Extension; Rip Fence Adjustments - Delta 36-6022 Instruction Manual

POINTER

USING THE RIGHT HAND TABLE EXTENSION

The table extension, located on the right side of the table, enables you to increase the width of the saw table to
accommodate oversized workpieces.
To use the table extension, refer to Figure 54 and do the following:
Release the table extension lock (B) by moving it up. Slide side table extension out to the right. Use the blue pointer on
the top scale to determine desired distance. When extension table is set to desired width, push lock lever to the lock
position.

RIP FENCE ADJUSTMENTS

To adjust rip fence so it is parallel to the blade, make adjustments to the set screws on the front of the fence as shown in
Figure 55.
MAKING ADJUSTMENTS
UNLOCK
LOCK
B
FIGURE 54
SET SCREW
FIGURE 55
EXTENSION
40
TABLE
HEX
WRENCH