Insert Throat Plate - Delta 36-6022 Instruction Manual

To reduce the risk of serious injury,
• the riving knife must be installed for every through cut and for every non-through cut unless the riving knife would
interfere with the cut.
• always use a blade with the correct thickness to match the riving knife. (0.10" (2.6mm) min. kerf width and 0.073"
(1.85mm) max body thickness)
• The riving knife must be securely positioned in the "up" or "through cut" position when using the antikickback pawls
and blade guard.
• Make sure the riving knife is properly aligned to the blade. (See Riving Knife Position and Alignment, Page 33.

Insert Throat Plate

Refer to Figure 22.
Place the throat plate (O) in place with the wear plate on the rear.
Engage the rear tab on the throat plate under the table and press the front end down until the front tab snaps into place
on the table.
ASSEMBLY
THRU CUT
POSITION
FIGURE 21
O
FIGURE 22
21
RIVING
KNIFE
LOCK
POSITION
WEAR
PLATE