Product Maintenance; Troubleshooting - Fellowes Powershred 225Ci Instructions Manual

PRODUCT MAINTENANCE

CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
2
AUTO
Turn off and unplug Locate Auto-start
shredder infrared sensor
OILING SHREDDER
noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you
empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

TROUBLESHOOTING

SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (225Ci only).
4
.
3
Dip cotton swab in
rubbing alcohol
AUTO
4
away any contamination
from the paper sensors
indicator will illuminate and the shredder will stop shredding. If SafeSense
®
ENGLISH
Models 225Ci/225i
®