GE PFH28 Owner's Manual & Installation Instructions page 29

Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
REMOVE THE REFRIGERATOR
3
DOORS (cont)
Note: For proper installation later, please follow
the next step carefully.
F
Remove the tape and keeping the door as
straight up to remove it.
center hinge
REMOVE OPPOSITE DOOR
There are no wires or water lines on the opposite
side.
4 REMOVE CENTER HINGE (if necessary)
to the cabinet.
Remove
center screw
screws
49-60748-3
REINSTALLING THE
5
REFRIGERATOR DOORS
Reverse steps 1 through 4 to reinstall refrigerator
doors, follow details below for critical alignments.
A
Reinstall center hinge
º then lift
first and torque the
screws to 65 in-lbs. With
front of the case, lower the
refrigerator door onto the
center hinge. Ensure that
the door and hinge align correctly.
B
Rotate doors closed and make sure moveable
center sealing portion of the door aligns with the
reinstalling, remove door, turn door upside down,
corresponds to an alignment arrow on the plastic
ring. Rotate door closure mechanism to align mark
Align flats with tab.
If door cannot be installed at 90° follow steps below:
on underside of door. The flats on the shaft should
correspond to alignment tab on plastic ring or
mark on bottom end cap.
Allen wrench, rotate door closure mechanism
shaft counterclockwise for right door and clock-
Securely tape the door shut with masking tape or
have a second person support the door. Reinstall
the top hinge and torque the screws to 65 in-lbs.
C
Be sure to reinstall the ground wire and strain
relief to the top hinge.
D
Reinstall hinge cover. NOTE: Ensure wires are not
pinched or under screw bosses before tightening
screws.
º to the