Makita 6833 Instruction Manual page 7

Removing the screw strip
To remove the screw strip, just pull it out in the direction of the arrow. If you depress the
reverse button, you can pull out the screw strip in the reverse direction of the arrow.
Carry hook
The carry hook is convenient for hooking
the tool to your belt. It can be installed on
either side
of the tool. To remove it, pull it
out in the direction of the arrow while rais-
ing. To install the hook, push
it
down until
it
"clicks" into place on the tool.
Switch action
CAUTl ON:
Before plugging in the tool, always check to see that the switch trigger actuates properly
and returns to the "OFF" position when released.
To start the tool, simply pull the trigger.
Release the trigger to stop. For continuous
operation, pull the trigger and then push in
the lock button. To stop the tool from the
locked position, pull the trigger fully, then
release it.
7 '