Wireless Transmitter And Receiver Adjustments - Sense SE-300-WT-HAND Manual

Wireless microphones wireless receiver
Table of Contents

Advertisement

6. WIreless Transmitter and Receiver Adjustments

The most important step is pairing the wireless receiver and transmitter's frequency. The wireless
receiver, body-pack transmitter, and hand-held wireless transmitter's setup menus function identically.
Each device has a SET, UP, and DOWN button to make adjustments to the frequency, group, sensitivity,
or pickup gain.
SE-300-WR-1CHD
Frequency Pairing
Match the frequency on both the transmitter and the reciever for wireless communication.
• Push the SET button once to select between frequency / group / sensitivity / RF outputs.
• Push the UP or DOWN button to adjust the setting of a menu.
• Press and hold SET for 3 seconds to activate that frequency.
• Once you see "MHz" blinking, you are ready to select your desired frequency by using the UP and
DOWN buttons.
• Push SET again to save the setting.
Group Adjusting
Multiple microphones can transmit on the same frequency using matching groups.
• Press SET for 3 seconds, the group (G) will flash on the LCD display.
• Push UP or DOWN to select a desired group.
• Push SET again and the Channel (CH) will flash.
• Push UP or DOWN to select the desired channel.
• Push SET again to save the setting.
Sensitivity Adjusting
Optimize sound pick up by adjusting the sensitivity. Caution: Increasing sensitivity can cause system
feedback.
• Press the SET button twice to select the sensitivity by holding it down for 3 seconds, releasing, and
pressing again for 1 second. The display will show "Sensit".
• Use the UP and DOWN buttons to make the necessary adjustments.
• Push SET again to save the setting.
RF Outputs
To adjust the transmission gain, select between low or high. For extended battery life, select "rF Lo".
• Push the SET button several times until the "rF Lo" or "rF Hi" flashes.
• Push UP to choose "Hi" for high transmitting power (50mW) and push DOWN to choose "Lo" for
transmitting power (10mW).
• Push SET again to save the setting.
Support: 866.838.5052
SE-300-WT-HAND
PG 7
SE-300-WT-BODY
|

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Se-300-wr-1chd

Table of Contents