Troubleshooting - Philips AJ6110 User Manual

Troubleshooting

WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
PHILIPS for help.
Problem
nocdor Errindication
No sound
The system does not react when buttons
are pressed.
Remote control does not work
Radio reception is poor
The Clock setting is erased
Solution
✔
No disc inserted. Insert a suitable disc
✔
Replace/clean CD
✔
CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W)
✔
Moisture has condensed in the player. Remove
the disc and leave the player power-on until the
moisture evaporates.
✔
Check whether the set is connected securely.
✔
Make sure the set is not in the MUTE mode. If it
is, press MUTE to turn on the speaker.
✔
Check whether the volume on the set has been
set to the lowest level. If it has, turn up the
volume.
✔
CD-ROM disc inserted/CD contains non-audio
files. Use CD Audio discs only.
✔
Remove and reconnect the AC power plug and
switch on the system again.
✔
Remove the protective plastic tab before using
the remote control.
✔
Reduce the distance between the remote
control and the set.
✔
Replace the battery.
✔
Point the remote control directly towards the IR
sensor.
✔
If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
✔
Increase the distance between the set and a TV,
VCR or radiation source.
✔
Power has been interrupted or the power cord
has been disconnected. Reset the clock.
17