Philips AJ3050 User Manual page 9

BATTERY LOW MODE
If you have inserted batteries, the battery low indicator
• battery power is low.
• you intend to use AC power, but the AC adapter connection is loose.
During the battery low mode, both Radio/Sleep, backlight and sound will not function.
Operation of any set alarm (Radio/Buzzer/Cockcrow) automatically changes to a slow
buzzer beep frequency.
• If the SLEEP / RADIO ON or
BRIGHTNESS CONTROL
low indicator will flash for 5 seconds and then remains non-blinking.
GENERAL FEATURES
Reset
Should you receive external interference e.g. static electricity from carpets, thunder-
storms, etc. which affects the display and electronic functions of your set, RESET
allows you to clear all previous settings and start up again.
• Use a ballpoint pen to press RESET, found on the bottom of the set.
Demo mode
When the set is first connected to a power supply or has been reset, 'PHILIPS' will
scroll continuously across the demonstration display.
• Press AL 2 button during the demo mode to listen to the cockcrow demo.
• Press SET TIME or SLEEP / RADIO ON to exit the demo mode, to set the time
or switch on the Radio.
Illumination brightness
Press REPEAT ALARM /
BRIGHTNESS CONTROL
• The brightness of the display will change in this sequence:
➟ ➟
bright dim backlight off (for AC adapter on)
• The brightness of the display will change in this sequence:
➟ ➟
off dim (5 seconds)
Note:
When the alarm or SLEEP function is active, the brightness cannot be adjusted.
lights up when:
button is pressed, the battery
once or more.
off (for Batteries)
SETTING THE CLOCK AND ALARM TIMES
The time is displayed using the 12-hour clock with PM indicator (PM off = AM).
1. Press SET TIME or SET ALARM 1 (or 2) to
enter the respective clock or alarm time setting
mode.
™ The clock time or the alarm time display
flashes and you will hear 'set time' or
'set alarm'.
2. Hold down or press HOUR or MINUTES
repeatedly to set and adjust the hours and min-
utes respectively. Release HOUR or MINUTES when you have reached the
correct setting.
3. After both the hours and minutes are set, press SET TIME or SET ALARM 1
(or 2) to confirm the setting.
• Time setting is also automatically confirmed 10 seconds after you set the time.
• It is not possible to adjust the alarm time during an alarm call or the repeat
alarm mode.
RADIO
1 Press SLEEP / RADIO ON once to switch on the radio.
2 Select your waveband using the BAND switch.
3 Adjust TUNING to find your radio station.
4 Adjust the sound using VOLUME.
5 Press ALARM RESET / RADIO OFF to switch off.
To improve reception:
For FM, extend and position the pigtail fully to obtain optimum reception.
For AM , the set is provided with a built-in aerial. Direct the aerial by adjusting the position
of your clock radio.