Philips AJ3050 User Manual page 8

CONTROLS
1 AL 1 - selects alarm 1 mode: OFF/ RADIO
2 AL 2 - selects alarm 2 mode: OFF/ BUZZER / COCKCROW
3 DISPLAY - shows clock and alarms (small display) times and status
4 REPEAT ALARM /
BRIGHTNESS CONTROL
- switches off the alarm for a 5 minute period
- changes display illumination brightness
- stops SLEEP function
5 ALARM RESET / RADIO OFF
- stops active alarm for 24 hours
- stops SLEEP / RADIO function
6 SLEEP / RADIO ON
- activates the radio for sleep function, and to select the sleep time
- switches the radio on
7 SET ALARM 1 : sets the alarm 1 time
8 SET ALARM 2 : sets the alarm 2 time
9 SET TIME : sets the clock time
0 HOUR : adjusts the hours for the clock and alarm times
! MINUTES - adjusts the minutes for clock and alarm times
@ Jack for AC/DC 7.5V adapter
# TUNING - tunes to radio stations
$ BAND - select FM-AM waveband
% VOLUME - adjusts the sound level
^ Pigtail - improves FM reception
& RESET - press if the set / display does not react to operation of any button
* Battery door - opens to store a 4 x R6/UM3/AA batteries (not included)
English
POWER SUPPLY
Batteries (not included)
1 Open battery door and insert four batteries (preferably PHILIPS POWER LIFE or
alkaline), type R6, UM3 or AA as indicated in the compartment.
2 Remove the batteries from the set if they are exhausted or not be used for a
long time.
• When the batteries are turning low,
backlight will not function, but the display and power saving buzzer will
continue to operate.
• When replacing batteries, the clock time, alarm setting will be stored by the
self-powered back-up for 1 minute (see 'Self-Powered Back-Up').
• Make sure the radio is switched off to save battery energy.
Batteries contain chemical substances, so they should be disposed of
properly.
Power adapter
1 Connect the power adapter to the set's DC jack and to the power outlet.
™ indicates the set is now adapter operated.
• Make sure your adapter is properly connected to save battery energy!
2 Always disconnect the power adapter if you are not using the set.
™ indicator goes out.
NOTE: To avoid damage to the set, use only the adapter supplied!
SELF-POWERED BACK-UP
The self-powered back-up conveniently allows your alarm and clock time settings to be
stored for up to 1 minute when there is a power interruption e.g. AC power failure or
when changing batteries.
The complete clock radio and backlight illumination will be switched off. As soon as the
power supply returns the display will indicate the correct time.
• If power supply returns after 1 minute, the demo mode appears and you will need to
re-enter all clock settings.
appears in the display. The radio and