Philips AJ3050 User Manual page 10

SETTING THE ALARM
GENERAL
If you wish to use the alarm, first set the alarm time before selecting your choice
of two alarm modes, radio or buzzer/cockcrow. The alarm display is shown con-
stantly, and the alarm indicator appears if the alarm is set.
• To select the radio alarm, press AL 1 button once.
™ The ALARM 1 display and m appear and you will hear 'Alarm ON'.
– Make sure you have adjusted the volume loud enough to wake you up!
• To select the buzzer or cockcrow alarm, press AL 2 button once or more.
™ The ALARM 2 display and
When reach Alarm setting time, Radio, Buzzer or cockcrow will switch on for
about 30 minutes and the alarm indicator flashes.
• Within seconds, your gentle wake alarm :
™ Buzzer option - increases its beep tone frequency.
™ Cockcrow option - increases volume.
Note:
If alarm by Radio and Buzzer/Cockcrow are activated at the same time, Alarm by
Buzzer/Cockcrow will dominate.
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24-hour ALARM RESET will be automatically selected after 30
minutes from the time your alarm first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain the
same alarm setting for the following day:
• Press ALARM RESET / RADIO OFF.
™ You will hear a beep tone confirming 24 hour reset activation.
The respective alarm display appears.
or appear and you will hear 'Alarm ON'.
REPEAT ALARM
This repeats your alarm call at 5 minute intervals.
• During the alarm call, press REPEAT ALARM /
™ The alarm indicator flashes during repeat alarm.
• Repeat if desired.
CANCELING THE ALARM COMPLETELY
• During alarm activated or repeat alarm mode, press and hold the AL 1 or AL 2
button for more than 1 second. Alarm will be switched off
completely.
™ The selected alarm indicator and alarm time disappears and you will hear
'Alarm OFF'.
SLEEP
About Sleep
This set has a built-in sleep timer, which enables the radio to be automatically
switched off after a set period of time. There are four sleep time options.
Setting and switching off SLEEP
1 Press SLEEP / RADIO ON to switch on the radio. The display shows 'ON'
shortly
2 Within 1 second, press SLEEP / RADIO ON again once or more to select your
sleep time.
• The display shows in sequence ON, and the sleep time options:
SL : 30, SL : 20, SL : 10 and OFF.
™ The Sleep indicator lights up.
3 To cancel sleep, press either:
– ALARM RESET / RADIO OFF
– REPEAT ALARM /
BRIGHTNESS CONTROL
.
BRIGHTNESS CONTROL
.