Advertisement
SETTING THE VOLUME
Set the VOLUME switch to either HI or LO to control the volume which is heard through the handset.
INSTALLATION
Plug the coiled end of the line cord into the jack at the end of the telephone. Plug the straight end of the line cord
into the wall telephone jack.
CHECK FOR DIAL TONE
Lift the handset and press the ON/OFF button. The button will light and you will hear a dial tone. The telephone
is now ready for use. After using, press the ON/OFF button again. The light will go off, and the telephone will
hang up.
BEFORE USING YOUR TELEPHONE
1. Set the ringer volume control. If the control is set to OFF, you will not hear the ringer a call is received.
2. Set the TONE/PULSE switch to match the dialing service from the telephone company.
a. If you set the switch for PULSE dialing and you have TONE service, you can dial numbers, but you
cannot use services, such as bank-by-phone, which require TONE signals.
b. If you have PULSE service, you can set the switch to PULSE to dial a service and then set the switch
to TONE to use the service. BE SURE TO SET THE SWITCH TO PULSE WHEN THE CALL IS
FINISHED.
c. If you set the switch for TONE dialing and you have PULSE service, you cannot dial calls.
SAFETY AND MAINTENANCE INSTRUCTIONS
IMPORTANT! PLEASE READ BEFORE USE
To keep your telephone in good working condition, please follow the instructions below:
•
Do not keep this unit in direct sunlight, moisture, in humid areas, or near appliances that give off excessive
heat.
•
Use a soft cloth dampened with water to clean the unit. Be sure to unplug the line cord before cleaning.
Do not use strong solvents or cleaning agents such as abrasives or powder, which may damage the phone
exterior.
•
Do not use the telephone while in a bathtub, shower, or pool. Immersion of the telephone in water could
cause electrical shock.
•
Avoid using the telephone or touching any telephone wires during an electrical storm. There is a risk of
electrical shock from lightning.
•
Always disconnect the unit from the wall outlet before servicing or disassembly.
FUSE – Listed (JDYX), rated 0.5A, 250V AC, pig-tail fuse
Advertisement
