JVC DR-MX10SE Service Manual page 12

< Note 2b >
• When reattaching the Front panel assembly, make sure that
the door opener of the Side frame (R) is lowered in position pri-
or to the reinstallation.
• When reattaching the Front panel assembly, pay careful attention
to the switch lever of the Front panel assembly not to make it
touch the switch knob of the Main board assembly from the side.
• When reattaching the Front panel assembly, lift the Cassette
door slightly.
Door
opener
Side
frame(R)
Fig.3-1a
< Note 3a >
• When reattaching the Mechanism assembly, secure the
screws (S3a to S3b) in the order of 1,2,3.
< Note 3b >
• When reattaching the Mechanism assembly, be sure to align
the phase of the Rotary encoder on the Main board assembly.
• When reattaching the Mechanism assembly, set the "Mecha-
nism assembling mode". [See "MECHANISM ASSEMBLY
SERVICE MANUAL (No. 86700)".]
After Assembling
FRONT PANEL
1-12 (No.YD084)
Switch
lever
Switch
knob
MAIN BOARD ASSY
(WR3b)
<Note 2a>
from FRONT PANEL
(OPE JACK CN7201)
(WR2a) <Note 2a>
DISPLAY/SWITCH
BOARD ASSY
Soldering side OPERATON JACK BOARD ASSY<27>
NOTE)INSERT FFC WIRE TO THE CONNECTOR
BEFORE ATTACHING TO FRONT PANEL.
OPERATON JACK BOARD ASSY parts surface
• When reattaching the Mechanism assembly to the Main board
assembly, take care not to damage the sensors and switch on
the Main board assembly.
< Note 3c >
• When reattaching the Drum assembly, secure the screws (S3c
to S3e) in the order of c, d, e.
(S3c)
(S3d)
(S3e)
Mechanism
assembly
• When handling the drum assembly alone, hold it by the motor
or shaft. Be careful not to touch other parts, especially the vid-
eo heads. Also take care not to damage the connectors.
FAN
(WR7a)
(WR7d)
<Note 2a>
(WR8b)
<Note 2a>
CN5302
(WR8c)
(WR8a)
<Note 2a>
CN5303
CN2001
(WR7c)
CN7107
(WR4b)
A/C HEAD
(WR7f)
(WR3a)
<Note 2a>
<Note 2a>
(WR7b)
DRIVE
UNIT
CN3102
BOTTOM SIDE
(WR2b) <Note 2a>
DISPLAY/SWITCH BOARD ASSY<28>
CN7001
NOTE)WHEN YOU FIX ANY PWB WITH THE SCREW,
PUT IT ON THE JIGS.
TOP SIDE
Fig.3-1d
(S3e)
(S3d)
Drum
HOOK
assembly
(S3c)
<Note 3c>
<NOTE>
Attach the Drum assembly appropriately,
since the installation state of the Drum assembly
influences the FM WAVEFORM LINEARITY
greatly.
Fig.3-1b
Shaft
Motor
Video heads
Fig.3-1c
CN5001
SWITCHING REGULATOR
BOARD ASSY
(WR5a)
<Note 2a>
(WR7e)
<Note 2a>
CN5304
D
JUNCTION BOARD ASSY
CN5501
CN5504
CN2101
CN2201
(WR4a)
<Note 2a>
DIGITAL BOARD
ASSY
CN1801
CN4104
DV JACK BOARD ASSY