Operation - Inateck BR1003 Instruction Manual

Operation

1) BR1003 recharging
Please charge the device when on low battery:
When the device is in working mode, if the WHITE LED flashes three
times continuously, it means the unit is working on low voltage, please
recharge the unit.
A. Please connect the charging cable to the adapter (USB output port)
or computer.
B. Connect the cable with BR1003.
C. In charging mode, the white LED turns on, it will turn off when fully
charged.
D. The entire charging time is around 2 hours.
Note:
1. Before using the product for the first time, please fully charge
BR1003.
2. If the device needs to be used while recharging, please connect the
device to the power supply before turning it on. Otherwise, the
device will reset immediately after connecting to the power supply.
3. There might be static noise if using a low quality power adapter. To
ensure the battery s lifespan, we would not recommend you to
continue using that device.
4. If the device will not be used for a long time, please recharge it every
month. It will protect the battery from complete discharge.
2) Bluetooth transmitter mode
Please slide the BR1003 button to TX side before turning it on.
Note:
1. It is required to do this operation before turning on the device.
2. All the paired device information in RX mode will be deleted from the
memory, after power on.
3. Please do not switch TX or RX mode after the device is turned on.
Also, please do not switch to RX mode immediately within 3 seconds
after turning the unit off. Because the unit is still having power, if
switching to RX mode immediately, it will still be in TX mode when
turning it on.