OBDII cable USB cable Contents Connect to How to program your car the computer. Product information Connect to the car. How to install PPC Sync 3 Synchronizing PPC Read data from car Support...
Connect PPC and the oBDii cable to the diagnostic connector continues on next page >> the connector is located under the steering wheel, often behind a cover, and sometimes under the ashtray. (More pictures at bsr.se/ppc) The circles show possible locations of the diagnostic connector.
Page 4
Start the car and drive for some the car.) programming once again. if the problem remains contact BSr support. minutes. after this you can remove the • always connect an electronic battery charger if the ppC performs a key as usual.
Many of the aftermarket Bovs actually offers less performance in comparison. “open air” Bovs are program. not to be used in cars with air mass meters, i.e. all cars younger than 10 years. BSr ppC software is calibrated for stock valves only.
It is necessary to install the PPC Sync 3 program to be able to download new software from BSR’s server to your PPC. Enter the website www.bsr.se/ppc and log in with your PPC number and password that were sent to your e-mail. Click on the PPC Sync 3 link to start the installation.
Page 7
Bsr sent to your e-mail. (Only necessary to do once.) if you have read your car’s original data it will be sent to BSr. on the basis of this BSr makes a new tuning software for your car.
Page 8
BSr via the internet and the ppC Sync 3 program. on the basis of. this is what we call a ”support agreement” .