Advertisement
Quick Links
Read this before assembly!
Carfully check for dirt and particles in all pipes
and hoses. Also check for dirt inside the filter.
At smallest hesitation, clean and wipe everyth-
ing thoroughly before assembly!
Check hoses for deformations, cracks or other
leakage. The clamps should be in good condi-
tion or to be replaced. Please note, when fitting
BSR air filter, do not tighten the air filter to hard,
be gentle. Check before and after testdrive that
everything are tight and firm.
Assembly instruction
Volvo S40/V50 T5 2004>
\\Server\bsr filer\Teknik\Monteringsanvisningar\OptiFlow\Volvo\Engelska\S40V50\Assembly instruction.pdf
Page 1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for BSR Optiflow
Summary of Contents for BSR Optiflow
- Page 1 The clamps should be in good condi- tion or to be replaced. Please note, when fitting BSR air filter, do not tighten the air filter to hard, be gentle. Check before and after testdrive that everything are tight and firm.
- Page 2 Assembly instruction Volvo S40/V50 T5 2004> Proposal of tools: •¼ Catch, Extender, socket 7, 8,10 mm •½ Catch, Extender, socket 15 mm •Phillips screw driver •Wire cutter •Wrench 8 mm •Car jack •Torx 25, 30 Remove the plastic cover (1) above the ECU Disconnect the battery.
- Page 3 Assemble the air mass meter and the ECU to the slide it down from right to left. Fit the steering pin Assemble the plastic ”washer” to the rubber- OptiFlow heat shield . Assemble the rod (9). (as under the Optiflow heat shield to the rubber bushing bushings (7).
Need help?
Do you have a question about the Optiflow and is the answer not in the manual?
Questions and answers