Operation - Greenlee EHP700L Instruction Manual

Battery-powered pump
Table of Contents

Advertisement

Operation

Inspect pump, hoses, couplers, and fittings for wear
or damage. Replace worn, damaged, or missing
components with Greenlee replacement parts. Worn
or damaged components can fail, resulting in injury.
Failure to observe this warning could result in severe
injury or death.
Electric shock hazard:
This tool is not insulated. When
using this unit near energized
electrical lines, use proper personal
protective equipment.
Failure to observe this warning
could result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Cutting hazard:
• Remove battery before changing
dies, adapters, or jaws.
• Keep hands away from the head
when in operation.
Failure to observe these warnings
could result in severe injury or death.
Greenlee / A Textron Company
EHP700L Battery-powered Pump
Skin injection hazard:
• Do not use hands to check for
leaks.
• Depressurize hydraulic system
before servicing or disconnecting
the hose.
High pressure oil easily punctures
skin, causing serious injury, gangrene,
or death. If injured, seek medical help
immediately to remove oil.
Electric shock hazard: The owner of this tool must
be certain that all users of this tool are trained in the
applicable safety codes and standards as well as in
the safe use of this tool and its accessories.
Failure to observe this warning could result in severe
injury or death.
• Do not use this tool for continuous use. After
100 cycles, allow the tool to cool for 15 minutes.
• Do not secure this tool in a vise. This tool is
designed for hand-held operation.
• Use this tool for the manufacturer's intended
purpose only.
Failure to observe these precautions may result in
injury or property damage.
Procedure for depressurizing the hydraulic system:
1. Disconnect the pump from the power source.
2. Press down on the manual release shaft and
allow the ram to retract fully.
3. Disconnect the hose slowly to release any
trapped pressure.
8
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070

Advertisement

Table of Contents
loading

Table of Contents