Table of Contents
Advertisement
VOD1023
To Secondary AV Monitor
To Secondary AV Monitor
INPUT
INPUT
12 VDC Power and Ground
12 VDC Power and Ground
VIDEO
VIDEO
Auxillary
Auxillary
video display
video display
1) Make the connections to the vehicle for the 12 pin wiring harness.
2) Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on
the main PCB and into the Mini-Din Connector on the main PCB.
3) Pull the wire tie loop tight and cut off the excess.
4) Connect the 12 pin harness to the mating connector on the Video Monitor.
5) Connect power harness to vehicle's electrical system by tapping into an accessory hot line and a
good ground.
6) Verify all functions of the System before final mounting of the finished assembly.
7) Mount and connect the Television antenna. (Optional)
Note: A VCP or other A/V Component can be connected to the video monitor system using a second
source component harness (purchased separately, part number: 8010730). This harness would plug
into the Mini-Din connector on the main PCB as in steps 2 and 3 above.
A/V Source Definitions:
1= AV1, VCP or VCP with TV Tuner (Mini-Din on main PCB)
2= AUX-IN (VCP, Game or future DVD etc...)
3= Built-in DVD
4= TV (TV Tuner)
*NOTE: If the original relay box P/N SIRSWB is installed, it recommended that the antenna for the
wireless FM Modulator be unplugged. See Figure A for antenna location.
**
NOTE: Extending the wireless antenna beyond its 12 inch length will cause the FM Modulator to exceed
FCC limits for wireless transmission. When installing the unit position the antenna for best
reception.
*
ANTENNA FOR WIRELESS FM MOD
**
See Antenna Note Below
*
OPTIONAL RELAY BOX
SIRSWB
CHOKE
CHOKE
Power Harness
Power Harness
Item #3
Item #3
RCA-Female
RCA-Female
TO
TO
TO
TO
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
LINE
LINE
ADDITIONAL
ADDITIONAL
ADDITIONAL
ADDITIONAL
OUT
OUT
MONITOR
MONITOR
MONITOR
MONITOR
Patch Cord
Patch Cord
VIDEO
VIDEO
RCA Male to Male
RCA Male to Male
(Yellow)
(Yellow)
Dome Light
Dome Light
Power Source
Power Source
Clean the IR Receiver Window on the front of the VCP.
Clean the IR Receiver Window on the front of the VCP.
Remove Adhesive Backing and Apply IR LED to IR
Remove Adhesive Backing and Apply IR LED to IR
Figure A
UNIT (BACK VIEW)
UNIT (BACK VIEW)
Line Out-L (White)
Line Out-L (White)
Line Out-R (Red)
Line Out-R (Red)
Line Out-V (Yellow)
Line Out-V (Yellow)
Power Harness
Accessory
Accessory
Item #3
Item #3
Harness - Optional
Harness - Optional
(P/N:8010730)
(P/N:8010730)
Red RCA (Audio Right)
Red RCA (Audio Right)
White RCA (Audio Left)
White RCA (Audio Left)
Yellow RCA (Video)
Yellow RCA (Video)
Power Connector
Power Connector
"Y" Adapter
"Y" Adapter
4 Pin
4 Pin
for use with
for use with
Non-Stereo
Non-Stereo
Installations
Installations
Item# 5
Item# 5
-6-
ANTENNA
ANTENNA
PODTVT
To TV Antenna In
To TV Antenna In
OPTIONAL
OPTIONAL
TV
TV
Advertisement
Table of Contents
