Hyundai HYEA5080 User Manual page 18

6.4. Gear box.
6.4.1. Use a high temperature gearbox grease. Such as Morris K323 Premium blue grease or
equivalent.
6.4.2. Check the gear box grease every 30 hours of use and fill as required. Thereafter check
and top-up after every 25 hours. N.B. 20 grams is sufficient for a full top-up.
6.4.3. To fill with or top-up with grease apply grease with a grease gun to the grease nipple.
6.4.4. Recommended change interval. 1st check after 30 hours of use. Thereafter every 25
hours of use.
If you do not follow these steps, deposit may arise in the carburetor.
This will cause starting difficulties and may cause permanent
damage
6.5. Storing the machine.
6.5.1. Perform all the general maintenance that the maintenance section of your
'User Manual' is recommended.
6.5.2. Clean the outside of the machine, drive axle, shield and nylon cutting head.
6.5.3. Remove all fuel from the fuel tank.
6.5.4. After all the fuel is drained, start the engine.
6.5.5. Allow the engine to run in idle until engine stops alone. This allows the fuel to
be removed from the carburetor.
6.5.6. Allow engine to cool down (about 5 minutes).
6.5.7. Use a spark plug wrench, remove the spark plug.
6.5.8. Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Slowly pull
the starter rope several times to coat internal components. Replace the spark plug.
6.5.9. Store the machine in a cool, dry place away from any source of ignition such as
an oil burner, water heater etc.
6.6. Transporting the machine.
6.6.1. When transporting the machine make sure that no fuel is allowed to leak
out.
6.6.2. DO NOT allow the trimmer/brush cutter come into contact with persons,
animals and property.
Page 18 Ver 3- December 2016