Table of Contents
Advertisement
4 IMPORTANT SAFETY RULES
Fig 1
1.
KEEP CHILDREN AWAY. All children should be kept away from the work area. Don't let
them handle the tool.
2.
USE SAFETY GLASS AND EAR PROTECTION: Air tool operators and others in work
area should always wear safety glass to prevent the injury from fasteners and flying
debris when loading and unloading this tool. Maybe the noise would harm your hearing,
wear the ear protection to safeguard.
(See fig 1.)
3.
NEVER USE OXYGEN, COMBUSTIBLE OR ANY OTHER BOTTLE GAS as a power
source or would cause explosion and serious personal injury.
(See fig 2.)
4.
DO NOT CONNECT TOOL TO COMPRESSED AIR which pressure exceeds 8.3 bar
(120psi).
5.
DO NOT PLACE OVER-LONG AIR HOSE in working area in case of the operator's
unexpected tripping .Make sure all connections are tight.
6.
CARRING TOOL ONLY BY THE HANDLE do not keep the trigger pull on safety yoke
mechanism to avoid unintentional firing of fastener.
7.
KEEP THE TOOL POINTED AWAY FROM YOURSELF and others at all time and keep
hands, any body parts away rear area to Safety guard against possible injury.
8.
DISCONNECT TOOL FROM AIR SUPPLY BEFORE LOADING fasteners to prevent a
fastener from being fired during connection. (See fig3.)
9.
DO NOT KEEP THE TIRGGER OR SAFETY DEPRESSED during loading fasteners or
the unintentional firing of a fastener would cause personal injury.
10. DISCONNECT TOOL FROM AIR SUPPLY HOSE and close the compressor before
performing maintenance, alter the accessories or during non-operation.
11. DO NOT DRIVE FASTENERS CLOSE TO THE EDGE OF THE WORK PIECE. The
workpiece would split allowing fastener to fly free or ricochet causing personal injury.
12. DO NOT DRIVE FASTENER ON TOP OF NAILED FASTENER, or the fastener can
ricochet causing personal injury.
13. NEVER USE A TOOL that is leaking air, had missing or damaged parts or requires repair
and make sure all the screws and securely tightened.
14. MAKE DAILY INSPECTION FOR FREE MOVEMENT of trigger, safety mechanism and
spring to insure the tool can operate well.
15. ONLY USE PARTS AND ACCESSORIES recommend by manufacturer.
Copyright © 2015
FAT-0113
Fig 2
P a g e
| 3
EN
Fig 3
www.Ford-tools.com
Advertisement
Table of Contents
