Setting Up The Remote Control To Work With Other Connected Equipment - Sony WEGA KE-MV42A1 Operating Instructions Manual

To select a Teletext page
Input three digits for the page number, using the
number buttons.
• If you make a mistake, retype the correct page
number.
• If the counter on the screen continues searching,
it is because this page is not available. In this
case, input another page number.
To access the next or preceding page
Press PROG + (c) or PROG – (C).
To superimpose Teletext on to the TV
While you are viewing Teletext, press /. Press it
again to cancel the Teletext mode.
To freeze a Teletext page
Some Teletext pages have sub-pages which follow
on automatically. To stop them, press t /
Press it again to cancel the freeze.
To reveal concealed information (e.g. answers
to a quiz)
Press . Press it again to conceal the
/
information.
To select a sub page
A Teletext page may consist of several sub pages.
In this case, the page number that appears on the
upper left corner will change from white to green
and one or more arrows will appear next to the
page number. Repeatedly press B or b on the
remote control to watch the desired page.
To switch off Teletext
Press a.
Fastext
The Fastext service lets you access pages with one
push of a button.
While you are in the Teletext mode and Fastext is
broadcast, a color coded menu appears at the
bottom of the Teletext page. Press the color button
(red, green, yellow or blue) to access the
corresponding page.
Setting Up the Remote
Control to Work with Other
Connected Equipment
This remote control is set by default to operate the
basic functions of this Sony TV, most Sony DVDs
and Sony VCRs when batteries are initially
installed. To control VCRs and DVDs of other
major brands, and certain Sony VCR models,
please complete the following steps:
Before you start, look up the three digit code for
your brand of DVD or VCR from the list on page
22. For those brands that have more than one code,
enter the first code number.
.
1
Press the Media Selector (MODE) button
on the remote control repeatedly until the
required VCR or DVD green light lights up.
Note
• If the Media Selector is in the TV position, code
numbers will not be stored.
2
Before the green light goes out, press and
hold the yellow button for approximately
six seconds until the green light starts
flashing.
1
3
2
,continued 21