Advertisement
Risk of electric shock!
Care
Maintenance
Pull out the mains plug!
Risk of explosion! No solvents!
Machine housing, control panel
- Wipe with a soft, damp cloth.
- Do not use abrasive detergents.
1.
- Immediately remove washing and cleaning agent residue.
- Do not clean the appliance with a water jet.
Clean the detergent drawer ...
2.
... if it contains detergent or fabric softener residue.
1.
Pull out, depress insert, completely remove.
Remove insert: Press insert upwards with finger.
2.
Clean detergent dispenser and insert with water and a brush and dry.
3.
3.
Attach insert and engage (connect cylinder to guide pin).
4.
4.
Insert detergent drawer.
5.
Leave detergent drawer open so that residual water can evaporate.
6.
Drum
Leave washing machine door open so that the drum can dry out.
Rust stains use chlorine free cleaning agent, not steel wool.
Descaling
No washing in the machine!
Not necessary if detergent dispensed correctly. However, follow the instructions of the descaler
manufacturer.
Information on the display panel
depending on model
1.
2.
F: 16
Close the washing machine door properly; washing may be caught.
3.
4.
F: 17
Turn on the tap, supply hose kinked/jammed;
Clean filter > Page 9; water pressure too low.
F: 18
Clean detergent solution pump -> Page 9; outlet pipe/drainage hose blocked.
1.
F: 23
Water in the base pan, appliance leaking. Call customer service!
F: 34
Door cannot be locked. Open door and close it with an audible click"; switch
appliance off and on again; set programme and select individual settings; start
programme.
F: 42, 43, 44
Motor fault. Call customer service!
2.
7
8
Risk of scalding!
What to do if ...
Allow deterhgent solution to cool down!
Turn off the tap!
Detergent solution pump
F
Water is running out.
Set programme selector to Off, pull out the mains plug.
F
Water not flowing in.
Open and remove service flap.
Detergent not washed
in.
Take the drainage hose out of the holder.
F
Washing machine door
Remove sealing cap, allow detergent solution to flow
cannot be opened.
out.
Put the closing cap back on the hose.
Programme does not
F
start.
F
Detergent solution is not
Carefully unscrew the pump cover (residual water).
drained.
Clean the interior, pump cover thread and pump housing
F
Water not visible in the
drum.
(fan impeller in the detergent solution pump must rotate).
F
Spin result not
satisfactory.
Re insert pump cover and screw on tight, handle is upright.
Insert the drain hose into the holder.
F
Spin cycle actuated
several times.
Insert and close service flap.
F
Dispenser
2
not
completely rinsed out.
To prevent unused detergent from flowing into the outlet during the next wash:
F
Odour formation in the
Pour 1 litre of water into dispenser II and start the Empty programme.
washing machine.
F
Foam is coming out of
Filter in the water inlet hose
the detergent drawer.
Risk of electric shock!
Do not immerse Aqua Stop safety device in water
(contains electric valve).
Release water pressure in the supply hose:
F
Intense noise formation,
Turn off the tap!
vibrations and
Select any programme (except Spin/Empty).
"wandering" during spin
cycle.
Select Start/Pause. Leave programme for approx. 40 seconds.
Set programme selector to Off. Pull out the mains plug.
F
Display panel/indicator
Clean filter:
lights do not function
Depending on model:
while the appliance is
Remove hose from tap.
running.
Clean filter with small brush.
F
Programme progress
longer than usual.
or
F
Detergent residue on the
Remove hose from the rear.
Remove filter with pliers and clean.
washing.
F
If a fault cannot be rectified or a repair is required:
Connect the hose and check for leaks.
- Set programme selector to Off and pull out the mains plug.
- Turn off tap and call customer service > Installation instructions, Page 7.
9
Safety instructions
- Correctly attach/replace drainage hose.
- Read and follow the operating and installation instructions and all other information enclosed
- Tighten screw fitting on the supply hose.
with the washing machine.
- Start/Pause not selected?
- Retain documents for subsequent use.
- Tap not open?
Risk of electric shock
- Never pull out the mains plug by tugging the power cord!
- Filter blocked? Clean filter -> Page 9.
- Never insert/pull out the mains plug with damp hands.
- Supply hose kinked or jammed?
Danger to life
Redundant appliances:
- Pull out the mains plug.
- Safety function active. Wait approx. 2 minutes.
- Sever the power cord and discard together with the plug.
- D (Rinse stop = without final spin) selected? -> Page 4.
- Destroy the lock on the washing machine door.
- Start/Pause or Finish in selected?
This will prevent children from locking themselves in and
- Washing machine door closed?
suffocating.
Risk of suffocation
- Keep packaging, plastic film and packaging parts out of the reach
- Clean detergent solution pump -> Page 9.
of children.
- Clean outlet pipe and/or drainage hose.
Risk of poisioning
- Keep detergents and care products out of the reach of children.
- Not a fault - water below the visible area.
Risk of explosion
- Caused by detergents containing solvents, e.g. stain
remover/items of washing pretreated with solvent naphtha may
result in an explosion after being loaded into the washing machine.
- Wash small and large items of washing together.
Before hand thoroughly rinse items of washing by hand.
- Less Ironing selected? -> Page 5.
Risk of injury
- Washing machine door may become very hot.
- Too low speed selected? -> Page 3.
- Caution when draining hot detergent solution.
- Not a fault - unbalanced load detection system adjusts
- Do not climb on the washing machine.
imbalance.
- Do not lean on the open washing machine door.
- Do not touch the drum in case it is still spinning.
- Remove the insert. Clean detergent drawer and insert > Page 8.
Consumption values
- Run Cottons/Coloureds 90 ºC programme without washing.
Use standard detergent.
- Too much detergent used?
Programme
Additonal
Mix 1 tablespoon of fabric conditioner with ½ litre of water and
function
pour into dispenser II in the detergent drawer.
Cottons/Coloureds 30 °C*
Intensive Wash
- Reduce detergent dosage for the next wash cycle.
Cottons/Coloureds 40 °C*
Intensive Wash
- Appliance feet fixed?
Cottons/Coloureds 60 °C
Intensive Wash
Secure appliance feet > Installation instructions, Page 5.
Coloureds eco 60 °C*
-
- Transportation safety devices removed?
Cottons/Coloureds 90 °C
Remove transportation protection devices > Installation
-
instructions, Page 3.
Easy Care 40 °C*
Intensive Wash
- Power failure?
Easy Care 40 °C
- Fuse tripped? Switch on/replace fuse.
(also suitable as Short
-
- If the fault occurs repeatedly, call customer service.
programme)
Delicate/Silk Å (cold)
-
Delicate/Silk 30 °C
- Not a fault - unbalanced load detection system adjusts imbalance
-
by repeatedly distributing the washing.
u
Wool Å (cold)
-
- Not a fault foam detection system active - a rinse cycle is
Wool 30 °C
u
-
started.
- Occasionally phosphate free detergents contain water insoluble
* Programme setting with maximum spin speed for conducting test according to currently valid
residue.
European Standard 60456.
- Select Rinse or brush the laundry after washing.
** The values deviate from the indicated values depending on water pressure, water hardness, water
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
detergent, fluctuations in the mains voltage and selected additional functions.
10
Operating instructions
Load
Current**
Water**
Programme
duration**
7.0 kg
0.55 kWh
73 l
2:12 h
7.0 kg
0.85 kWh
73 l
2:12 h
7.0 kg
1.50 kWh
73 l
2:12 h
7.0 kg
1.19 kWh
49 l
1:50 h
7.0 kg
2.20 kWh
85 l
2:00 h
3.5 kg
0.55 kWh
53 l
1:12 h
Washing
3.5 kg
0.54 kWh
53 l
0:45 h
machine
2.0 kg
0.03 kWh
39 l
0:40 h
2.0 kg
0.20 kWh
39 l
0:40 h
2.0 kg
0.07 kWh
30 l
0:40 h
2.0 kg
0.17 kWh
30 l
0:40 h
Read these instructions before switching on the washing machine!Also
follow the separate Installation instructions.
Follow the safety instructions on page 11!
11
en
Advertisement
