Loading Paper; Paper - Sharp AL-1035-WH Operation Manual

LOADING PAPER

When there is no paper on the feed tray, the "paper required" indicator (
The output tray must be expanded before normal copying or printing operations, otherwise, the machine will not
warm up.

PAPER

To achieve the best result, please use the paper recommended by SHARP.
Paper type
Standard paper A4
A5
Recycled paper
A6
8.5 × 11*
5.5 × 5.5*
3
Thick paper*
Thin paper
Labels –
*1
When printing a large amount of copies or using the 80g/m
printed. Otherwise, a pile-up error may occur.
*2
The quantity of paper loadable to the feed tray differs for different paper weights.
*3
If a feeding error occurs when using thick paper, you will need to load the paper one sheet at a time into the feed tray.
*4
Appliable for the inch system.
Special paper
Please observe the following standards when using special paper.
● When using paper not recommended by SHARP, please operate in single-sheet mode (do not try to
perform continuous copying or printing)
● There are many types of special paper, some of which cannot be used in this machine. Before using
special paper, please contact the authorized service department.
● Before using paper not recommended by SHARP, please carry out a copying test to check if it is suitable.
Size
56g/m
4
4
91g/m
56g/m
–
) will be on.
Weight
2 2 1
to 80g/m * 40 pieces *
(Standard paper:
80g/m
height shall be less
than the paper guide
size limit.)
2 2
to 128g/m –
2 2
to 59g/m –
–
2
paper, empty the output tray every time when 10 sheets have been
7
Capacity
2
2
, the feeding