Power Architecture; Power Supply Unit; Diversity; Power Architecture Tv550 Platform - Philips Q552.1A Service Manual

Table of Contents

Advertisement

7.2

Power Architecture

Refer to figure
Figure 7-5
platform.
7.2.1

Power Supply Unit

All power supplies are a black box for Service. When defective,
a new board must be ordered and the defective one must be
returned, unless the main fuse of the board is broken. Always
replace a defective fuse with one with the correct
specifications! This part is available in the regular market.
Consult the Philips Service web portal for the order codes of the
boards.
Important delta's with the TV543 platform are:
New power architecture for LED backlight (PSL, PSLS,
PSDL)
"Boost"-signal is now a PWM-signal + continuous variable.
The control signals are:
Standby
Lamp "on/off"
DIM (PWM) (not for PSDL)
Boost (PWM except for IPB)
Power-OK: indicates that the main converter is functioning
(feedback signal to the SSB).
In this manual, no detailed information is available because of
design protection issues.
The output voltages to the chassis are:
+3V3-STANDBY (standby-mode only)
+12V (on-mode)
+Vsnd (+24V) (audio power) (on-mode)
+24V (bolt-on power) (on-mode)
for the power architecture of this
Figure 7-5 Power Architecture TV550 platform
Circuit Descriptions
Output to the display; in case of
- IPB: High voltage to the LCD panel
- PSL and PSLS (LED-driver outputs)
- PSDL (high frequent) AC-current.
7.2.2

Diversity

The diversity in power supply units is mainly determined by the
diversity in displays.
The following displays can be distinguished:
CCFL/EEFL backlight: power board is conventional IPB
LED backlight:
- side-view LED without scanning: PSL power board
- side-view LED with scanning: PSLS power board
- direct-view LED without 2D-dimming: PSL power board
- direct-view LED with 2D-dimming: PSDL power board.
PSL stands for Power Supply with integrated LED-drivers.
PSLS stands for a Power Supply with integrated LED-
drivers with added Scanning functionality (added
microcontroller).
PSDL stands for a Power Supply for Direct-view LED
backlight with 2D-dimming.
back to
div. table
Q552.1A LA
7.
18770_234_100127.eps
EN 47
100127
2010-Jun-25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents