Ssb Replacement Flowchart - Factory Mode - Philips Q552.1A Service Manual

EN 36 5. Q552.1A LA
Noisy picture with bands/lines is visible and the
RED LED is continuous on.
- Press the "volume minus" button on the TVs local keyboard for 5 ~10
- Press the "SOURCE" button for 10 seconds until the "F" disappears
2010-Jun-25
Service Modes, Error Codes, and Fault Finding
Set is st art in g u p in F act o ry m o d e
Set is starting up in F actory m ode?
from the screen or the noise on the screen is replaced by "blue mute"
The noise on the screen is replaced
with the blue mute or the "F" is disappeared!
Unplug the mains cord to verify the correct
disabling of the Factory mode.
Program display option code
via "062598 MENU", followed by
the 3 digits code of the display
on a sticker
After entering "display option" code, the set is
going in stand-by mode (= validation of code)
Figure 5-12 SSB replacement flowchart - Factory mode
An "F" is displayed (and the HDMI 1
seconds
(this code can be found
on - or inside - the set).
R estart the set
back to
div. table
input is displayed).
H_16771_007b.eps
100322