Normal Starting - Skytrak MMV Owner's/Operator's Manual

1. (S/N MV1210 & After) Make sure the battery shut-off switch in the
engine compartment is in the "ON" position.
2. Enter the cab and adjust the seat for comfortable operation.
3. Adjust the mirrors to obtain the best rear view from the operator's
position.
WARNING:
the seat with the seat belt fastened around you. Death or serious
personal injury could result if the belt is not securely fastened.
4. Fasten the seat belt.
5. Make sure the parking brake switch is ENGAGED.
6. Place the travel select lever in (N) NEUTRAL.
7. Move the Neutral Lock Lever to the (N) NEUTRAL LOCK Position.
8. Push and turn the ignition switch to the START position (fully clock-
wise) to crank the engine. Release the ignition switch when the
engine starts. If the engine fails to start on the first try, wait until the
engine and starter come to a complete stop before cranking the
engine again.
IMPORTANT! DO NOT crank the starting motor continuously for more than
30 seconds. Stop cranking the starter and allow the starter to cool for 2
minutes before engaging the starter again.
9. After the engine starts, run engine at partial throttle for 30 to 60 sec-
onds before operating the vehicle. Return to idle before engaging
the travel or range select levers.
10. Move the Neutral Lock Lever to the (D) DRIVE Position before you
start operating.
11. Disengage the parking brake switch before you start operating.
Model MMV Rev. 10/11

Normal Starting

DO NOT start the engine unless you are in
Operation
67