Operating Instructions; Using The Led Flashlight; Jump-Starting A Vehicle - Viking 62749 Owner's Manual

Operating Instructions

Using the LED Flashlight

1. Press and hold the Main Power
Button about one second to turn on
the Power Pack. The blue indicator
lights on the Control Panel will
illuminate, indicating the unit is on.
2. To turn the Flashlight on, press
the Flashlight Button.

Jump-Starting a Vehicle

Note: Read the vehicle owner's
manual pertaining to jump-starting
prior to using the Power Pack.
NOTICE: To avoid damage to the vehicle's
electrical system, do not use the Power Pack
on a vehicle that has no battery installed.
1. Verify that the Power Pack is fully
charged and recharge as needed,
following the instructions in Charging
the Power Pack on page 7.
2. Turn off the vehicle ignition
switch and all accessories (lights,
radio, climate control, etc.).
3. Plug the Battery Clamp Cable
into the Engine Start Socket on
the side of the Power Pack.
WARNING! DO NOT TOUCH
POSITIVE AND NEGATIVE
BATTERY CLAMPS TOGETHER.
4. Connect the red Positive Battery Clamp
to vehicle's positive battery terminal.
Then connect the black Negative
Battery Clamp to the vehicle chassis.
WARNING! DO NOT CONNECT TO THE
NEGATIVE TERMINAL OF THE BATTERY.
Page 8
For technical questions, please call 1-888-866-5797.
3. For an SOS signal, press the
Flashlight Button again.
4. For a flashing light, press the
Flashlight Button again.
5. To turn the Flashlight off, press
the Flashlight Button again.
Note: Flashlight will shut off
automatically after 30 minutes.
5. When the correct connection has been
made, press and hold the Main Power
Button about one second to turn on
the Power Pack. Press and hold the
Starter Button about one second until
the green light comes on indicating
unit is ready to jump-start vehicle.
WARNING! RISK OF EXPLOSION.
If the Battery Clamps are connected
incorrectly, a beep will sound and the red
warning light on the Control Panel will
light. Press and hold the Main Power
Button to turn off the unit. Correct the
connections and repeat step 5.
6. Attempt to start the vehicle. If the
vehicle does not start after 5 to 8
seconds, stop and wait at least
1 minute before trying again.
7. After the vehicle is started, press and
hold the Main Power Button about one
second until the green indicator light
goes out to turn off the unit. Remove
the black Negative Battery Clamp first,
and then the red Positive Battery Clamp.
8. Recharge the Power Pack.
Item 62749