Operation; Lighting The Fire; Re-Lighting The Fire; Turning Off The Fire - Wonderfire 2570 Owner's Manual

Operation 13
Operation
Lighting the Fire .
Step 1. Turn the thermostat, if any, to its 10000st setting.
Step 2. If the pilot is lit already, proceed to 'Relighting the
Fire' below.
Before lighting the pilot, make sure thatthe valve is in the OFF
position by pushing in the gas control knob slightly and turning
it clockwise to 'OFF: Also, put the ONlOFF/f'STAT switch.
located at the left rear of the stove, in the OFF position.
Step 3. Smell for gas. Inspect the unitfor any obvious sign
of damage or deterioration. If damaged, do not attempt to light.
Step 4. Locate the pilot under the front log in the lower left
handcomerofthefirebox. When lit, thepilotwill produceasmall
but steady flame.
Step 5. Turn the knob on the gas control counterclockwise
to ·PILOT.'
Step 6. Light the pilot by pushing the control knob all the
way in and holding it there. Immediately push the red ignitor
button; push it more than once if required to light the pilot
Continue to hold the control knob in for about one (1) minute
after the pilot is lit. Then, release the knob and it will pop back
up. The pilot should remain lit.
NOTE: Once the pilot has been lit, it will remain lit continu­
ou&ly.
Step 7. Turn the gas control knob counterclockwise to
'ON:
Step 8. Place the ON/OFF/f'STAT switch in the ON
position and continue to watch thefire until the entire burner is lit. For
thermostatic control. set yourthermostat and then place the remote
switch in the T'STAT position.
CAUTION
If the entire fire is not lit within five (5)
seconds of turning the remote rocker switch
ON, immediately push the remote rocker
switch to OFF. Allow five (5) minutes for the gas to
clear from the firebox. Repeat from Step 2.
Jf again unsuccessful. completely turn off all gas to
the stove. Call your local WonderfireDealer or gas
i
Turning Off the Fire
Step 1. Simply push the remote rocker switch to OFF. The
pilot wil Iremain on. You can leave the pilot running. (It costs less
than 1 cent an hour to run.)
You may hear a popping noise from within the firebox a
few seconds after shutting the stove off. This is normal and
does not indicate a problem.
NOTE: If you do not intend to operate the unit for an
extended period of time, it is a good idea to turn the gas control
knob to OFF and to turn the manual gas valve on the supply line
to OFF-as well.
ON/OFF/f'STAT Switch
3-Way Switch Settings
ON: Continuous burning.
OFF: Gas is shut off.
T'STAT: Gas flow to burner is.
controlled by external thermostat
setting.
Control
Valve Knob
Pilot location
and flame pattern
Re-lighting the Fire
Step 1. Check to see if the pilot is on.
Step 2. Turn on the remote rocker switch and watch to be
sure the entire burner lights.