Roland soljet pro4 xf 640 User Manual page 38

Loading Media

Loosen the retaining screws of the media holder [Left].
Hold the outside of the media holder and align the left edge of the media with the mark.
When deciding the position, hold the both sides of media holders from the outer sides and move it. Do
not hold the media directly to move.
CAUTION
2
After this procedure is completed, if the left and right side positions do not fit the proper position
when securing the media with pinch rollers, go back to this step to redo this procedure. Printing
quality is affected due to skew media feed, if you hold the media only to readjust the position forcibly.

Secure the media holder by tightening the securing screws slightly.
The retaining screw may get damaged if tightened excessively.
36
Never attempt this operation while holding any location other than the
one specified.
The media may fall from the media holder, resulting in injury.
Decide the left and right side positions of the media finally at this step.
Mark