WEG SCA-05 Installation Manual page 4

Step 6: Loose the screws indicated in the figure
to remove the control module metallic lateral (E).
It allows the access to the SCA-05 control board
(F).
Step 8: Remove the mounting screws located
around the DB9 connector from the
communication board (figure detail).
Step 9: Attach the communication board to
the product carefully, aligning the pins bus
with the control board XC12 connector and
seating the board properly on the standoffs.
Step10: Securely tighten the communication
board to the metallic standoff with the screw you
removed earlier. Replace the mounting screws
around the communication board DB9 connector
fastening them to the product metallic cover.
Once the Profibus DP communication kit is installed, reassembly the control module
and reconnect it to the power module.
NOTE
Remember to reconnect all the cables removed during the kit
installation before proceeding with the SCA-05 Servo Drive operation.
For a complete description of the SCA-05 Servo Drive operation using Profibus
DP communication protocol, refer to SCA-05 User's Guide
03
Step 7: Remove the screw from the position
indicated by the arrow and insert the metallic
and plastic standoffs into the SCA-05 control
board holes, as illustrated in the figure. Keep
the screw for later use.
Observe the correct orientation for the plastic
standoff (figure detail)
E
F
.
XC12