Sony KV-HR36M31 Service Manual page 52

4-7-1. Landing Adjustment
In case of no lack of uniformity, it is no need to adjust.
1. Set to the service mode.
2. Select the category "LAND". The cross hatch and the marker
appear on the screen
3. Set to the coarse adjustment by pressing ''9" on the remote
commander.
4. Adjust upper and lower sides on the screen. (Edges of Y axis)
1) Move the marker to the center on the screen and set
LO
green single color.
Move the marker by pressing
1 .l
, + and
-+
buttons on
the remote commander.
The crosshatch appears on the screen, but the marker
moves to the position only as shown in the figure. Set the
marker to the center on the screen and press "ENTER".
Then it becomes the adjusting mode. To return to move
the marker, press "EhTER" again.
To change the single color red, gTeen or blue, press "6".
Xote: In case of receiving TV signal. a single color is mixed
to the TV signal. It is easy to adjust in VIDEO 1 to 3
without input because only a single color is displayed.
2 ) Landing adjustment
Adjust with the remote commander
+ -
and
-+
to reduce
the lack of uniformity on upper and lower side on the
screen.
After adjustment, press "ENTER. Then it becomes to
moving marker mode and the crosshatch appears on the
scree~i."
5. Adjust right and left sides on the screen. (Edges of X axis)
Set the marker to right or left and adjust landing in the same
manner as the item 4.
6 .
Adjust on the comers.
Set the marker to the comers and adjust landing in the same
manner as the item
4.
It can be adjusted from any comer.
7. Write the adjusted data to the memory by pressing "MUTE"
and "I 2" on the remote commander.
Ityems
2, 3
Itvem
4- 1)
Ityem
5 In
case of the marker is on the left side.
Ityem
6
In case of the marker is on the upper right side.