Table of Contents
Advertisement
en
Not suitable
-
Cutlery and utensils made of wood.
-
Delicate decorative glasses, craft and
antique utensils. These decors are not
dishwasher -proof.
-
Plastic parts not resistant to heat.
-
Copper and tin utensils.
-
Utensils which are soiled with ash, wax,
lubricating grease or ink.
Aluminium and silver parts have a
tendency to discolour and fade during the
wash cycle. Even some types of glass
(e.g. crystal glass objects) may turn cloudy
after many wash cycles.
Glass and utensil damage
Causes:
-
Glass type and glass production
process.
-
Chemical composition of the detergent.
-
Water temperature of the wash
programme.
Recommendation:
-
Use only glasses and porcelain which
the manufacturer designates as
dishwasher-proof.
-
Use a detergent which protects
utensils.
-
Take glass and cutlery out of the
dishwasher as soon as possible after
the programme ends.
10
Loading the dishwasher
-
Remove large food remnants. It is not
necessary to prerinse utensils under
running water.
Place the utensils so that
they are secure and cannot tip over.
-
all utensils with their openings face
down.
parts with curves or indentations
are at an angle, thereby allowing
water to drain.
-
does not obstruct rotation of the
two spray arms
I
22
I
and
[2!].
Very small utensils should not be washed
in the machine, as they may fall out of the
baskets.
Unloading the dishwasher
To prevent water from dripping off the
upper basket onto the utensils in the lower
basket, it is recommended to empty
the appliance from the bottom up.
Hot utensils are sensitive to shock!
Therefore, when the programme ends,
leave the utensils to cool down in the
dishwasher until they can be handled.
Cups and glasses
Top basket 12.[]
* depending on model
The majority of faults which could occur in
daily operation can be rectified by the
user. This ensures that the appliance is
quickly available for use again. The
following overview will help you locating
the causes and gives helpful advise to
eliminate them.
Note
If the appliance stops during dishwashing
for no obvious reason, first run the Abort
programme function (Reset).
(See chapter entitled "Basic functions")
&.
Warning
Don't forget: Repairs may be carried out
by technicians only. If a component has to
be replaced, ensure that only original
spare parts are used. Improper repairs or
use of non-original spare parts may cause
considerable damage and put the user at
considerable risk.
Waste water pump
Large food remnants in the rinsing water
not retained by the filters may block
the waste water pump. The rinsing water
is then not pumped out and covers
the filter.
In this case:
First disconnect the appliance from
the power supply.
-
Remove the bottom basket.
-
Remove the filters 1281.
(See chapter entitled Maintenance
and care)
-
Scoop out water, use a sponge if
required.
en
-
Using a spoon, prise off pump cover
(as illustrated) until it clicks, then grip
the cover by the lug and pull it out
forwards.
-
Check inner compartment and remove
any foreign objects.
-
Place cover in the original position,
press down and engage.
-
Install filters.
Note
If the cover is not engaged properly, this
may cause a programme interruption and
the "Tap .._, display
W
is indicated.
19
Advertisement
Table of Contents
