Download Print this page

Philips CED750 Quick Start Manual page 2

Philips in-dash car dvd quick start guide
Hide thumbs Also See for CED750:

Advertisement

3
4
English
navigation computer, the computer may
lost its memory.
If the car battery is not disconnected,
Connect wires: ISO connectors
to avoid short-circuit, ensure that bare
wires do not touch each other.
2
Ensure that car dashboard opening is within
these measurements:
1
Pull out the ISO connectors from the car
dashboard and connect them to the bigger
Since the unit cannot be used if the
end of the supplied standard connector.
dashboard opening's slant angle is above
20 degrees: Ensure that the horizontal
2
Connect the other end of supplied standard
slant of the car dashboard opening is
connector to the unit.
between 0 and 20 degrees
If necessary, connect the following:
3
Remove the screws on the both side of the
unit.
Connector Connect to/with
4
Remove the mounting sleeve.
1
Black cable
Antenna
5
Install the sleeve into the dashboard and
2
Yellow cable Video out 1
bend the tabs outward to fi x the sleeve.
3
Yellow cable Video out 2
6
Place the rubber cushion over the end of the
4
Yellow cable Camera in
bolt.
7
5
Green/white
Parking
Slide the unit into the dashboard until a click
wire
sound is heard.
6
Black cable
Bluetooth microphone
If the unit cannot fi t into the dashboard,
remove the mounting bracket on the
7
Blue cable
Subwoofer
both side of the unit and replace them
8
Red cable
Front line out L
with the supplied short mounting
9
White cable Front line out R
brackets.
8
0
Red cable
Rear line out L
Attach the trim plate.
9
Reconnect the negative terminal of the car
!
white cable Rear line out R
battery.
Mount in the dashboard
Turn on
1
Press the
Note
The screen opens automatically.
»
Check wire connection before you mount
The available OSD (On-Screen Display)
»
the unit into a car.
languages are displayed.
2
If preset radio stations are lost when the
Touch a language to select.
ignition key is turned OFF and then back
The OSD language is changed to the
»
ON, reconnect the red leads crosswise to
selected language immediately.
the yellow ones.
To adjust the screen tilt, press
To close the screen, press
1
If the car does not have an on-board drive or
To adjust the brightness/contrast, press
navigation computer, disconnect the negative
then adjust 4 WAY NAVIGATION .
terminal of the car battery.
To turn off the system, press
If you disconnect the car battery in
onds.
a car that has an on-board drive or
The screen closes automatically.
»
Set clock
1
Touch
to display main menu.
2
Touch [Setting].
The setup menu is displayed.
»
3
Touch [General].
4
Touch the [Clock mode] repeatedly to
select:
[12hr]
: 12 hour mode
[
24hr] : 24 hour mode
5
Touch the hour digits, then touch
6
Touch the minute digits, then touch
7
If 12 hour mode is selected, touch
to select AM or PM .
8
Touch
to exit.
Tune to a radio station
1
Touch
to display the main menu.
2
Touch [Radio].
Band and frequency infor mation is
»
displayed.
3
Touch [Band] repeatedly to select:
FM band options:
AM band options:
4
Briefl y touch [Previous] or [Next] to tune
to a radio station by step.
Play discs
1
Insert the disc into the disc slot with label
to turn on the unit.
side facing up.
Play starts automatically.
»
To remove the disc, press the
»
When the disc is ejected, the unit switches
»
to the previous source, if connected. Other-
wise, the unit switches to [Radio] mode auto-
matically.
TILT .
OPEN/CLOSE .
Insert USB or SD/MMC card
/ ,
for 3 sec-
1
Open the USB/SD/MMC card cover.
2
Insert the USB device or SD/MMC card into
the USB socket or SD/MMC card slot.
Play starts automatically.
»
Pair the Bluetooth-enabled
devices
1
Turn on the Bluetooth function on the
device.
2
Setup the Bluetooth function on your device.
or
.
3
Select "CED750" in the pairing list.
or
.
4
Enter default password "0000".
or
[Connect] is displayed
iI pairing succeeds.
»
on the panel.
Make a call
1
Pair the phone with the system.
2
Touch
to return to main menu.
3
Touch [Bluetooth].
The Bluetooth menu is displayed.
»
4
Touch to dial.
FM1, FM2, FM3
AM1, AM2
Receive call
1
If there is incoming call, [Incoming call...]
fl ashes on the screen. Speak into the Blue-
tooth microphone.
2
When conversation ends, touch
terminate the call.
button.
© 2008 Koninklijke Philips Electronics N.V.
All rights reserved.
to

Advertisement

loading

This manual is also suitable for:

Ced750/98