Installation - Panasonic CQ-DFX972N Operating Instructions Manual

Mp3 cd player/receiver with full dot matrix display and cd changer control
Table of Contents

Advertisement

Installation

E
N
G
L
I
Preparation
S
H
¡Before installation, check the radio operation with
27
antenna and speakers.
¡Disconnect the cable from the negative (–) battery
terminal (see caution below).
¡Unit should be installed in a horizontal position with the
front end up at a convenient angle, but not more than
30°.
30° or less
Caution: Do not disconnect the battery terminals of a
car with trip or navigational computer since all user
settings stored in memory will be lost. Instead take
extra care with installing the unit to prevent shorts.
Dashboard Installation
Installation Opening
The unit can be installed in
any dashboard having an
opening as shown at right.
The dashboard should be
4.5 mm - 6 mm thick in order to be able to support the
unit.
Installation Precautions
This product should be installed by a professional
installer, if possible.
In case of difficulty, please consult your nearest authorized
Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery
system (car) with negative ground.
2. Follow the electrical connections carefully (
Failure to do so may result in damage to the unit.
3. Connect the power lead (red) after all other connections
are made.
4. Be sure to connect the battery lead (yellow) to the
positive terminal (+) of the battery or fuse block (BAT)
terminal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation
instructions of the respective equipment before
connecting it to this unit.
30
182 mm
a
CQ-DFX972N
Supplied Hardware
No.
q
Mounting Collar
w
Mounting Bolt (5 mmø)
e
Power Connector
r
Removable Face Plate Case
t
Trim Plate
y
ISO Antenna Adapter
u
Lock Cancel Plate
Methods for Fixing the Rear of the Unit
(a) Using the Rear Support Strap (Option)
Tapping Screw (Option)
53 mm
(b) Using the Rubber Cushion (Option)
Page 34).
Item
Diagram
Fire Wall of Car
3 mmø
Hex. Nut (Option)
Rear Support Strap (Option)
w Mounting Bolt
q Mounting Collar
Rear Support Bracket
(Provided on the car)
Rubber Cushion
(Option)
w Mounting Bolt
q Mounting Collar
Q'ty
1
1
1
1
1
1
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents