Table of Contents
Advertisement
3
Enter the entire ShowView number. This number is up to 9 digits long
and can be found next to the start time of the TV programme in your
TV listings magazine.
e.g. 5-312-4 or 5 312 4
Enter 53124 for the ShowView-number.
If you make a mistake, you can clear your instructions with CLEAR
(CL) .
SELECT
Using
, select from the following options:
: Recording once
: Repeated daily recordings (Monday to Friday)
: Repeated weekly recordings (every week on the same day)
4
Confirm with OK .
a
b The programme number of the TV channel has not yet been assigned to
the ShowView number. Using the number buttons
control, select the corresponding programme number (name) of the TV
channel and confirm with
a
b The entered ShowView number is incorrect. Correct your instructions or
MENU
end with
b Check the time/date (see chapter 'Installing your video', section 'Setting the
time and date').
a
b A daily recording was entered for the wrong day. Daily programming can
only be used for recordings to be made from Monday to Friday.
5
The decoded data appears after confirmation. You can go back to
change the data. Select the corresponding input field using
SqP or QSr . Change the data with P ;q , P =r or
with the number buttons 0-9 .
Select the '
' input field using
'VPS/PDC' (' ' lights up). If you press
'VPS/PDC' off (' ' goes out).
6
When all informations are correctly, confirm with
programming information is stored in a TIMER block.
7
Insert a cassette with an intact security tab (unprotected).
OK
.
.
SqP
. Using
SELECT
Programming a recording (TIMER)
0-9
on the remote
SELECT
switch on
again, you will switch
OK . The
Advertisement
Table of Contents
