Table of Contents
Advertisement
TV channels from a satellite receiver (connected to the scart socket EXT.2 AV. 2 ) are
received on the video recorder on programme number 'E2'.
To do this, select programme number 'E1' with 0 on the remote control and then select
programme number 'E2' with P =r .
You should select the TV channels to be received by the satellite receiver directly on the
receiver itself.
During installation, all available TV channels are searched for and saved. If the channel
assignments of your cable or satellite TV provider change or if you are reinstalling the video
recorder, e.g. after moving house, you can start this procedure again. This will replace the TV
channels already saved with the new ones.
1
Switch on the TV set. If required, select the programme number for
the video recorder.
2
Press the MENU button on the remote control. The main menu will
appear.
3
Select line '
4
Press OK .
5
Select the country of your residence with P ;q or P =r .
If your country doesn't appear, select '
6
Press OK .
7
The automatic TV channel search starts. This allows the video
recorder to save all available TV channels. This procedure may take
several minutes.
8
When the TV channel search is complete, '
on the TV screen.
9
To end, press MENU .
You can read about how to search for a TV channel manually in the section 'Manual TV channel
search'.
' using P =r or P ;q .
'.
' will briefly appear
Installing your video recording
Advertisement
Table of Contents
