Bissell AEROSWIFT 1009 SERIES User Manual page 9

Maintenance: Check Brush & Belt
In Step 1 and 5, you will need a Phillips
screwdriver.
1
Unplug vacuum, turn over
and unscrew 3 Phillips
head screws and remove
bottom cover.
4
Place belt back on motor gear. Pull belt over the
brush roll and place back in. Position the brush roll
end opposite of the belt to line up with tab. The
end closest to the belt will slide in the tab without
needing any rotation.
2
Grasp the rotating brush
at both ends and lift out.
3
Inspect brush roll by placing
it on its end and spin. The
brush roll should spin freely,
multiple times by one flick.
If it doesn't, replace brush
roll. Inspect belt, replace if
it appears damaged.
5
Re-attach bottom replacing
the 3 screws. Spin the brush
by hand one revolution to
self-center the belt.
www.BISSELL.com
9