Table of Contents
Advertisement
CHAPTER 2
Safety Instructions
WARNING: To prevent fire or electrical shock, do not expose the device to rain
or moisture.
The encoder modulator is powered with a voltage of 12V DC. The power supply
voltage must not exceed the recommended voltage, which otherwise may
cause irreparable damage to the device and the invalidation of the warranty.
Therefore:
• Do not replace power supply with a voltage greater than 12V DC.
• Do not connect the device to the power if the power cord is damaged.
• Do not plug the device into mains supply until all cables have been connected
correctly.
• Do not cut the cord.
Avoid placing the device next to central heating components and in areas of
high humidity.
Do not cover the device with elements that obstruct the ventilation slots.
If the encoder modulator has been kept in cold conditions for a long time, keep it in
a warm room minimum 2 hours before plugging into the mains.
Mount the encoder modulator in vertical position with the connectors located on the
top side.
When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer or have the same characteristics
as the original part. Unauthorized substitutes may result in fire, electric shock or
other hazards.
Safety check- Upon completion of any service or repairs to this device, ask the
service technician to perform safety checks to determine that the device is in proper
condition.
Safety Instruction and Installations
Home Use
7
Advertisement
Table of Contents
